Seite 1 von 2

Fluence BCI battery charge impossible

Verfasst: Mi 12. Feb 2020, 13:57
von Pszemo
Hi. Dose anyone solve the problem with BCI. I have isolation level 2 problem. The car starts normal but after 5 mile drive I get first message BCI. I can drive even 50 miles but once I stop and turn the ignition off and start again I get message Electric motor fault. After 20 minutes all errors are gone and I can drive again. Can I put used parts, motor, charger and peb to fix my car?

Re: Fluence BCI battery charge impossible

Verfasst: So 16. Feb 2020, 18:28
von cancer038
I had the same problem. engine electrical failure. :((

Re: Fluence BCI battery charge impossible

Verfasst: So 16. Feb 2020, 21:30
von terkaa
cancer038 did you resolve it? And how?

Tero

Re: Fluence BCI battery charge impossible

Verfasst: Mo 17. Feb 2020, 11:19
von Pszemo
I have bough used motor from crashed car. I will replace on the Saturday and let yous now. Hopefully that will help. I heard that only PEB cannot be replaced by used part.

Re: Fluence BCI battery charge impossible

Verfasst: Mo 17. Feb 2020, 21:38
von terkaa
Hi,

Ok pls let us know. I have been thinking that it might be possible to swap PEB from another vehicle if you take control PCB(upper pcb) from your old PEB and all other parts from another one. I am not sure if it is possible just my own thinking... Power electronics that usually fail are in lower part of PEB unit.

Also would it Be possible to swap PEB from another car If you also swap EVC from same car...

Tero

Re: Fluence BCI battery charge impossible

Verfasst: Di 18. Feb 2020, 05:27
von terkaa

Re: Fluence BCI battery charge impossible

Verfasst: Di 18. Feb 2020, 21:42
von Pszemo
What is EVC and where is located?

Re: Fluence BCI battery charge impossible

Verfasst: Sa 29. Feb 2020, 06:19
von terkaa
Hi,

If I have understood correctly EVC is synonym for ECU in electric cars. I do not know where it is located in Fluence. How did your motor replacement go? Here is a good video of PEB dismantling and explanation of its functions:

https://www.youtube.com/watch?v=drS3sEsxOO8&t=2s

Tero

Re: Fluence BCI battery charge impossible

Verfasst: So 5. Apr 2020, 20:16
von jmbpinto73
Pszemo hat geschrieben: What is EVC and where is located?
EVC is beside the 12V battery , several cables conect to it. But I doubt you could get away with just the PEB and EVC swap...I read Battery pack must be matted with the EVC for the car to work.

Re: Fluence BCI battery charge impossible

Verfasst: Mo 6. Apr 2020, 20:51
von terkaa
Hi,

Seriously? Remember that this car has a quick change system for battery. So I do not believe that BMS has to match EVC.

Tero

Tero