Simple EVSE Wallbox - Relais switching

Alles rund ums Elektroauto-Laden / Ladeboxen / Ladegeräte

Simple EVSE Wallbox - Relais switching

njordan
  • Beiträge: 154
  • Registriert: Do 14. Jun 2018, 16:18
  • Hat sich bedankt: 4 Mal
  • Danke erhalten: 1 Mal
read
Hi,
i have a question regarding the EVSE DIY wallbox. I setup everything, even with ESP8266, works fine in dry-run....means the LED changes blinking as soon as i start charging via button or in GUI.....what i was wondering, why the RELAIS does not switch in these moments.......my only guess is that the Wallbox-HW waits for a real car connected on the other end.....

Can that be the case (that relais really switches on/off only if the car is connected?)

Thanks Norbert
Anzeige

Re: Simple EVSE Wallbox - Relais switching

USER_AVATAR
  • E-lmo
  • Beiträge: 3745
  • Registriert: Mo 19. Sep 2016, 16:24
  • Wohnort: Neuenhagen bei Berlin
  • Hat sich bedankt: 271 Mal
  • Danke erhalten: 735 Mal
read
Yes. Due to electrical safety - there should be no Voltage on the disconnected charging Plug.
Seit Mai 2016 mit einem e-UP unterwegs -- Skoda Enyaq seit Mai 2021

Re: Simple EVSE Wallbox - Relais switching

njordan
  • Beiträge: 154
  • Registriert: Do 14. Jun 2018, 16:18
  • Hat sich bedankt: 4 Mal
  • Danke erhalten: 1 Mal
read
Cool. thanks....now it all makes sense :-)

Re: Simple EVSE Wallbox - Relais switching

njordan
  • Beiträge: 154
  • Registriert: Do 14. Jun 2018, 16:18
  • Hat sich bedankt: 4 Mal
  • Danke erhalten: 1 Mal
read
Last question, does anybody know how the SimpleEVSE realizes that the car is connected.

PP is terminated with a resistor inside of the PLUG itself, so this line does not reach the Wallbox Controller.
L & N are outputs....the same i guess is valid for CP with the PWM signal....so these lines are not intended to get input from?

Cheers
Norbert

Re: Simple EVSE Wallbox - Relais switching

UliZE40
  • Beiträge: 3833
  • Registriert: Mi 16. Nov 2016, 20:14
  • Hat sich bedankt: 325 Mal
  • Danke erhalten: 799 Mal
read
CP is bidirectional. The car communicates to the EVSE by adding resistors and a diode between CP and PE to pull down and cut off the PWM voltage.

Re: Simple EVSE Wallbox - Relais switching

njordan
  • Beiträge: 154
  • Registriert: Do 14. Jun 2018, 16:18
  • Hat sich bedankt: 4 Mal
  • Danke erhalten: 1 Mal
read
Thanks!!...
AntwortenAntworten

Zurück zu „Ladeequipment“

Gehe zu Profile
  • Vergleichbare Themen
    Antworten
    Zugriffe
    Letzter Beitrag